Groups: Registered
Joined: 5/11/2006(UTC)
Posts: 472
Location: Texas
Thanks: 58 times
Was thanked: 169 time(s) in 110 post(s)
|
I was so excited it finally recognized my machine and both cartridges after the update. it printed fine BUT it ejected the mat before moving on to cut out the images.
Anyone know why or what to do?
It is also VERY slow uploading the project to cut.
jana
|
|
|
|
|
|
Groups: Registered
Joined: 12/29/2008(UTC)
Posts: 652
Location: Heath, Texas
Thanks: 51 times
Was thanked: 464 time(s) in 199 post(s)
|
I had the exact same problem.
|
|
|
|
|
|
Groups: Registered
Joined: 5/8/2008(UTC)
Posts: 426
Location: Michigan
Thanks: 170 times
Was thanked: 110 time(s) in 77 post(s)
|
I don't think at this time it cuts with imagine...
I can get as far as printing too...then the imagine screen pops back to "connected" and spits out mat.....
Jodi
|
|
|
|
|
|
Medals:  Groups: Registered, Circle Member
Joined: 2/21/2009(UTC)
Posts: 10,844
Location: Illinois
Thanks: 8631 times
Was thanked: 4374 time(s) in 2913 post(s)
|
Originally Posted by: JodiBarber  I don't think at this time it cuts with imagine...
I can get as far as printing too...then the imagine screen pops back to "connected" and spits out mat.....
Jodi It's not just the Imagine. I'm using the Expression and when I went to CUT something on the mat the other day, it simply spit the mat back out of my machine!! I tried it several times; it spit back out each time. It didn't like what I was doing; but, there was no indication what I could do to fix the problem! Char
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.