Groups: Registered
Joined: 11/14/2010(UTC)
Posts: 1
|
I am new to cricut and I am helping my daughter make a display board for a science project. We want to make stacked letters for the title on the board, but I can't figure out how to accomplish this. Can anyone help me?
|
|
|
|
|
|
Groups: Registered
Joined: 8/30/2010(UTC)
Posts: 114
Thanks: 11 times
Was thanked: 7 time(s) in 7 post(s)
|
If you cut out the letter and then cut out the letter in the same size, but using the shadow function, I think you will be able to get the effect you are looking for. Just make sure the real dial size is off. HTH
|
|
|
|
|
|
Groups: Registered
Joined: 1/5/2009(UTC)
Posts: 1,073
Location: Close to golf balls and squirrels
Thanks: 71 times
Was thanked: 173 time(s) in 150 post(s)
|
Which cart are you using? Not all letters have shadows.If your cart does not have a shadow then you could increase the size.Like cut one letter at 1" and then at 1 1/4".It doesn't look the same but it's close to a shadow. Or you can cut them at the same size and just layer them slightly offset.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.