Groups: Registered
Joined: 12/12/2008(UTC)
Posts: 101
Location: East Tennessee
Thanks: 3 times
Was thanked: 6 time(s) in 6 post(s)
|
Okay, I have searched and searched to figure out how to cut the picture which is attached. The machine is wanting to cut each individual image out. It will start on the scalloped circle, then the regular pink circle, then the white circle and the letters out individually. How do I get cricut craft room to just cut the scallop out and print the rest only? I have tried welding, which only results in the images taking the other color over and then i tried grouping and that did not work either. I am at the end of my rope!!! Thank you, Jennifer dncnqueen02 attached the following image(s):
|
|
|
|
|
|
Medals:  Groups: Circle Member, Registered Joined: 2/19/2011(UTC) Posts: 5,297  Location: 'Almost Heaven' West Virginia Thanks: 11443 times
Was thanked: 8770 time(s) in 2682 post(s)
|
I'm not a CCR user, so I can't help, but you might get a better response posting in the CCR forum or PMing Narelle directly. She can probably answer your questions. HTH
|
|
|
|
|
|
Medals: Groups: Circle Member, Registered Joined: 5/12/2010(UTC) Posts: 5,082  Location: Southwest Washington State Thanks: 1160 times
Was thanked: 2052 time(s) in 1260 post(s)
|
Originally Posted by: dncnqueen02  Okay, I have searched and searched to figure out how to cut the picture which is attached. The machine is wanting to cut each individual image out. It will start on the scalloped circle, then the regular pink circle, then the white circle and the letters out individually. How do I get cricut craft room to just cut the scallop out and print the rest only? I have tried welding, which only results in the images taking the other color over and then i tried grouping and that did not work either. I am at the end of my rope!!!
Thank you,
Jennifer Unless you have an old version of CCR, there's really not a way to do this. There are some workarounds... You can stop the machine when it goes to cut. Some people then put it in with just the layer they want it to cut without moving it etc and try running it through as cu tonly. Some people have merged it all together and then used an E2 if they have one to cut it. I'd cross check with Narelle like Coah suggested in case she's found another way as she uses CCR with her Imagine. :)Khrista
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.