Groups: Registered
Joined: 5/8/2012(UTC)
Posts: 1
|
i just purchased an expression2 the cutting blade is installed as described yet it is barely nicking the paper.
|
|
|
|
|
|
Groups: Registered
Joined: 11/10/2011(UTC)
Posts: 160
Thanks: 14 times
Was thanked: 112 time(s) in 70 post(s)
|
Benson, I usually have my green blade housing set at 4,5, or 6 to cut most things. Hope this helps... but if it doesn't you can always call Cricut Support and they will help you figure out why it isn't working right for you and their number is listed under SUPPORT/contact us.
|
|
|
|
|
|
Groups: Registered
Joined: 12/21/2008(UTC) Posts: 343  Location: USA Thanks: 7 times
Was thanked: 82 time(s) in 67 post(s)
|
Check that the housing is exactly where it should be. When I got my first expression, I installed the housing wrong and it wouldn't cut anything until I realized my mistake. Good Luck!
|
|
|
|
|
|
Medals:  Groups: Circle Member, Registered
Joined: 2/22/2009(UTC)
Posts: 4,123
Location: Minnesota
Thanks: 2208 times
Was thanked: 2287 time(s) in 1656 post(s)
|
On a new machine the blade depth is usually set at 1, which won't cut most things. You need to have the blade depth set at 3 or 4 to cut basic cardstock. Also be sure your pressure setting is not too low either.
|
|
|
|
|
|
Groups: Registered
Joined: 8/17/2007(UTC)
Posts: 1
Location: Ohio
|
I just opened my E2 and I am having the same problem...tried changing the blade...that didn't work....guess my next step will be a phone call.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.