Groups: Registered
Joined: 9/6/2010(UTC) Posts: 14  Location: Southern California Thanks: 13 times
|
Hey Cricut-eers!
I have an Expression 1 and have been using the CCR this evening (California time) and I get an "update" message to update firmware for my cricut machine to run better with CCR. So...of course...I update. I see it's a three part update and it has been 45mins and it's still on part one of updating. Is this normal? Has anyone else had this issue? I'm half tempted to turn off and start fresh.
Any feed back will be greatly appreciated.
Thank you.
|
|
|
|
|
|
Medals:  Groups: Circle Member, Registered Joined: 9/26/2006(UTC) Posts: 9,631  Location: Brisbane, Australia Thanks: 1833 times
Was thanked: 6610 time(s) in 3101 post(s)
|
Originally Posted by: TammyZajc  Hey Cricut-eers!
I have an Expression 1 and have been using the CCR this evening (California time) and I get an "update" message to update firmware for my cricut machine to run better with CCR. So...of course...I update. I see it's a three part update and it has been 45mins and it's still on part one of updating. Is this normal? Has anyone else had this issue? I'm half tempted to turn off and start fresh.
Any feed back will be greatly appreciated.
Thank you. It definitely shouldn't take that long. If you're Expression is already at firmware of 2.43 then you don't need to do the update at all. I'm not sure what will happen if you exit now. If the Expression won't work as normal just run the update again.
|
|
|
|
|
|
Medals: Groups: Registered, Circle Member
Joined: 2/21/2009(UTC)
Posts: 10,859
Location: Illinois
Thanks: 8650 times
Was thanked: 4381 time(s) in 2919 post(s)
|
I was also told to UPDATE my FIRMWARE for my Expression this past week. I did it, because I figured everyone else was getting the same message when they opened their Expressions to use for the first time after the update was posted.
It was already on 2.43! So, of course, I figured they were giving us a newer number!!
WRONG! There was no new number. It took longer than other firmware updates have taken (maybe ten minutes). After it finished, I went ahead and cut a project I was working on at the time the update popped up. IT CUT JUST FINE....thanks goodness.
I thought this was interesting at least one other person had an UPDATE message come up.
Char
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.