Groups: Registered
Joined: 11/8/2007(UTC)
Posts: 33
Location: Wisconsin
Was thanked: 8 time(s) in 4 post(s)
|
 What do you do to fix your blade dragging? I have so many extra cuts, and I don't know what to do. Thanks to all who take the time to reply. Joan
|
|
|
|
|
|
Groups: Registered
Joined: 8/21/2009(UTC) Posts: 341  Location: SE Coastal Georgia Thanks: 16 times
Was thanked: 102 time(s) in 50 post(s)
|
Not exactly sure what you mean by blade dragging but if you mean it drags across on the machine than you have the blade setting too low to the machine such as a 6 which is closest to the machine, 5 a little higher, 4 a little higher than a 5, etc.
Also depends what you are cutting causing it to drag and where you have it set at for blade setting.
|
|
|
|
|
|
Groups: Registered
Joined: 1/27/2008(UTC)
Posts: 122
Location: NW Ohio
Thanks: 11 times
Was thanked: 201 time(s) in 25 post(s)
|
i've read about this here in the past and i believe what worked for some is to reset the machine. Here's how you do it. good luck! i think there are other solutions, so come back here if this doesn't work for you!
|
|
|
|
|
|
Groups: Registered
Joined: 6/15/2007(UTC) Posts: 1,815  Location: Queensland Australia Thanks: 265 times
Was thanked: 249 time(s) in 154 post(s)
|
have you removed your blade from the housing, blow out the housing, sometimes there is stuff in there that makes you blade do funny things
hope this helps
|
|
|
|
|
|
Groups: Registered
Joined: 1/14/2009(UTC)
Posts: 594
Location: Idaho
Thanks: 290 times
Was thanked: 118 time(s) in 112 post(s)
|
Also make sure the blade is in its housing correctly and that it is tightened down. HTH. Mine didn't something similar to that and the housing had wiggled loose after a lot of cutting.
|
|
|
|
|
|
Medals:  Groups: Registered, Circle Member Joined: 3/22/2009(UTC) Posts: 2,807 Thanks: 1106 times
Was thanked: 833 time(s) in 696 post(s)
|
I have had this same problem..if it is what I think you are saying..rough cuts along some of the edges? I reset my machine and now ot cuts like butter 
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.