Groups: Registered
Joined: 8/23/2012(UTC)
Posts: 3
|
My vinyl cuts aren't coming out right, the blade seems to be skipping and instead of cutting a solid line the cut lines are coming out like they're perforated instead of completely cut through. Does that make sense? So instead of the excess vinyl peeling away easily I'm having to use my craft knife to cut through dotted spots. (cuts look like this ------ rather than this ________  ) I've changed my pressure, speed and blade settings and put a new blade in. Ideas?! I'm using my Cricut expression with Sure Cuts A Lot, and it was working fine until today after I changed my blade the first time. Thanks!!
|
|
|
|
|
|
Groups: Registered
Joined: 11/1/2010(UTC)
Posts: 513
Thanks: 10 times
Was thanked: 171 time(s) in 125 post(s)
|
I wonder if you have a bad blade, even though its new. Check to make sure you have it in right, and that the blade housing has been installed right. Here is a video on installation for reference: Blade installation video
|
|
|
|
|
|
Groups: Registered
Joined: 6/25/2012(UTC) Posts: 19  Was thanked: 5 time(s) in 4 post(s)
|
An easy check would be to put your old blade back in and test it. If it cuts ok, then it must be a bad new blade.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.