Groups: Registered
Joined: 1/3/2010(UTC)
Posts: 510
Thanks: 81 times
Was thanked: 224 time(s) in 102 post(s)
|
I have had my mini for a few weeks now & am having problems with my mini cutting clean. I have adjusted my pressure on the blade housing and also using the lever to control the pressure. I have also put a new blade in. When it first did it, I thought it had something to do with the paper that I was trying to cut, but it is also doing it with thicker paper. I would appreciate any advice you can give me!  Thanks!
|
|
|
|
|
|
Groups: Registered
Joined: 1/14/2009(UTC)
Posts: 594
Location: Idaho
Thanks: 290 times
Was thanked: 118 time(s) in 112 post(s)
|
You might want to check the blade housing where the blade goes in and make sure there is no paper "lint" stuck in it. Also, make sure the blade housing is installed properly and securely. HTH
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.