Groups: Registered
Joined: 8/26/2009(UTC)
Posts: 2
|
I was trying this weekend to cut out the sun and cloud along with the saying that goes with it. I cut it out just like the booklet showed, with Shift and No Shift, however all 4 pieces did not line up properly. I did not have the real dial size on and did not change the size during the cutting process. 2.5 inches was what I was going for. Anyone know how you get these pieces to line up and layer properly?? Thanks for help!
|
|
|
|
|
|
Groups: Registered
Joined: 1/9/2009(UTC) Posts: 4,899  Location: Northern Wyoming Thanks: 390 times
Was thanked: 2398 time(s) in 1681 post(s)
|
I'm sorry I can't help ... I use Design Studio and the pieces all fit together using that..Hope some one else can help!!
|
|
|
|
|
|
Groups: Registered
Joined: 8/26/2009(UTC)
Posts: 2
|
Can anyone help with the above question? I don't have Gypsy nor Design Studio. Just cricut and the cartridge. Thanks, Tiffany
|
|
|
|
|
|
Groups: Registered
Joined: 9/10/2008(UTC)
Posts: 503
Location: Plymouth, IN
Thanks: 162 times
Was thanked: 139 time(s) in 106 post(s)
|
I'm not completely sure what your problem may be. I don't have anything to assist me either & I'm having no issues. The only thing I would suggest is to NOT cut the shadow background image. It's not shown on the picture of the image, but they have it as one of the cuts (the 2nd cut). I think it creates confusion for some.You only need it if you want the entire image outlined. I didn't check that out, but that may be what's causing the lining up issue. If that's not it, I don't know what else to tell you.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.