Groups: Registered
Joined: 11/25/2010(UTC)
Posts: 2
|
My expression is about 6 weeks old and the pass few cut, the mat slides... Not the paper the mat.
I am using a new mat..
Any suggestions?
|
|
|
|
|
|
Medals:  Groups: Circle Member, Registered Joined: 5/12/2010(UTC) Posts: 5,079  Location: Southwest Washington State Thanks: 1159 times
Was thanked: 2049 time(s) in 1257 post(s)
|
What do you mean by the mat slides? If you're using the 12x12" mat it shouldn't be sliding. Can you describe what you mean a little more and then we might be able to better help.
:)Khrista
|
|
|
|
|
|
Groups: Registered
Joined: 11/25/2010(UTC)
Posts: 2
|
KimberlyRandazzo wrote:My expression is about 6 weeks old and the pass few cut, the mat slides... Not the paper the mat.
I am using a new mat..
Any suggestions? When cutting it slides from right to left, almost like the rubber wheels are not holding the mat in place
|
|
|
|
|
|
Medals: Groups: Circle Member, Registered Joined: 9/26/2006(UTC) Posts: 9,629  Location: Brisbane, Australia Thanks: 1833 times
Was thanked: 6609 time(s) in 3100 post(s)
|
And you ARE using a 12"x12" (square) mat? Not the 6"x12" (rectangle) mat? (Silly question... but it had to be asked because it HAS been done..)  Try feeding it in the opposite way (the side that has the hanging hole in it) and see if that makes any difference. Have you used anything in the cricut that might have gotten onto the rollers?
|
|
|
|
|
|
Medals: Groups: Circle Member, Registered Joined: 7/12/2008(UTC) Posts: 20,581 Location: Alpharetta Georgia Thanks: 6887 times
Was thanked: 14943 time(s) in 6965 post(s)
|
Also, make sure your mat is up against the loading guide on the right side of the loading bay when you put the mat in. If it's on the guide, it can cause it to move around.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.