Groups: Registered
Joined: 6/29/2008(UTC)
Posts: 1
|
I have just started using the cricut studio. The firmware appears to be updated. When I try to cut I can not load the mat. I am not to savy on all this, can someone help?
|
|
|
|
|
|
Groups: Registered
Joined: 1/9/2009(UTC) Posts: 4,899  Location: Northern Wyoming Thanks: 390 times
Was thanked: 2398 time(s) in 1681 post(s)
|
Mmmmm .. ?? Do you mean DESIGN Studio?? Make sure you put the mat far enough in the machine so the rollers catch it.. then hit LOAD MAT on the machine's key board..
|
|
|
|
|
|
Medals:  Groups: Registered, Circle Member
Joined: 6/5/2010(UTC)
Posts: 1,385
Location: South Texas Coast, MQ #349
Thanks: 652 times
Was thanked: 396 time(s) in 272 post(s)
|
I use the Gypsy with my cricut a lot and find that - 1 being sure the mat is pushed in until you meet resistance (don't push so hard you bend the mat!) and 2 putting my hand near the top of the mat where it goes in and "helping" it along as it loads - makes things go a lot better. You just want to make sure the mat contacts the rollers, be sure you don't actually push the mat in.
HTH!
|
|
|
|
|
|
Groups: Registered
Joined: 1/18/2007(UTC)
Posts: 9,716
Location: Sunny S. Florida
Thanks: 926 times
Was thanked: 2261 time(s) in 1788 post(s)
|
do you have a cart inserted into your machine? the machine wont load the mat without a cart. also you have to use the "load mat" on the machine as DS doesn't have a "load mat" button
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.