Groups: Registered
Joined: 2/4/2009(UTC)
Posts: 2
|
Hey guys - i need some help - i use my cricut expression to cut a lot of photos and vinyl - but lately it makes marks from where it goes across the paper from one cut to the next - i'm not sure why it is doing it - i've replaced the mat and the blade and played with the pressure, speed, and blade depth - i'm at a lost as to what else to try - it did not use to make these marks but now it is almost every cut - any suggestions????
|
|
|
|
|
|
Groups: Registered
Joined: 11/10/2009(UTC)
Posts: 563
Location: NC
Thanks: 69 times
Was thanked: 103 time(s) in 93 post(s)
|
Have you tried removing the blade and making sure there isn't a small piece of paper or vinyl stuck up in the blade holder? This sometimes causes issues with cutting.
|
|
|
|
|
|
Groups: Registered
Joined: 2/4/2009(UTC)
Posts: 2
|
I have tried looking into the housing unit once i replaced the blade - but i see nothing - thanks for the suggestion though - any other ideas?
|
|
|
|
|
|
Medals:  Groups: Circle Member, Registered Joined: 7/12/2008(UTC) Posts: 20,721  Location: Alpharetta Georgia Thanks: 6968 times
Was thanked: 15101 time(s) in 7021 post(s)
|
The reset procedure should cure this problem. Go to the old MB and at the top of the Cricut Products Help forum, you will find the reset procedure posted by AdminBecky.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.