Medals:  Groups: Circle Member, Registered
Joined: 12/1/2011(UTC)
Posts: 1
|
I am trying to print from my lap top to my Imagine from Cricut Craft Room. When I pressed cut, it printed out my letters & images, and then cut them out but they are off slightly. I thought it was my machine, so I recalibrated the settings and tried it again, with the same result. What can I do to get the printing and cutting to line up. It is pointless to use the CCR with the Imagine if you can't use the patterns and colors with it lining up.
|
|
|
|
|
|
Medals: Groups: Circle Member, Registered Joined: 2/19/2011(UTC) Posts: 5,373  Location: 'Almost Heaven' West Virginia Thanks: 11738 times
Was thanked: 9006 time(s) in 2740 post(s)
|
Is the alignment correct when you DO NOT use CCR? If it is, then it's just a compatibility issue between the Imagine and CCR. PC has said it will only support the Imagine as a stand alone machine, although if you call them, they may have some suggestions.
If the alignment is NOT correct even without CCR, there used to be advanced calibration instructions in a sticky at the top of this forum that may be helpful for you to try.
If you have your heart set on using CCR and can't get the calibration right, there is always the two step process. Print paper with your chosen pattern/color and then cut the images you want using that paper. HTH
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.