Groups: Registered
Joined: 9/26/2012(UTC)
Posts: 1
|
Why is it that when I use CCR and my digital downloads, every time I want to change mats to cut something, I have to restart the CCR and my Expression 2. It will not cut unless I close everything and restart it. This is very time consuming and extremely irritating. If I just use my Expression 2 and not the CCR, then there is no problem cutting. Any ideas would be greatly appreciated. Thanks!
|
|
|
|
|
|
Groups: Registered
Joined: 11/6/2012(UTC)
Posts: 17
Thanks: 4 times
Was thanked: 3 time(s) in 3 post(s)
|
I have been having a similar problem, and also after each cut sometimes it will not load the mat and I have to switch off and start from scratch again 
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.