Groups: Registered
Joined: 11/21/2009(UTC)
Posts: 109
Location: Paisley, Scotland
Thanks: 19 times
Was thanked: 26 time(s) in 20 post(s)
|
I recently bought the scoring blade for TBBM2 but can't seem to get it right. How do I get the score in the right place? I'm getting very frustrated and will be grateful for any advice.
|
|
|
|
|
|
Groups: Registered
Joined: 1/3/2010(UTC)
Posts: 510
Thanks: 81 times
Was thanked: 224 time(s) in 102 post(s)
|
Have you looked on YouTube for a tutorial?
|
|
|
|
|
|
Groups: Registered
Joined: 2/26/2011(UTC)
Posts: 7
Location: Illinois
Was thanked: 1 time(s) in 1 post(s)
|
It depends, if you are using a gypsy, all you have to do is cut normally. Then do not press unload mat, instead select return to design. You then change to the scoring blade and switch to the scoring image (make sure the size is the same and that the image is on the same x and y plots) then press cut again.
If you do not have a gypsy, you still do not press unload after cutting, you press load paper again and the cutting mechanism will return to the default position. You will then change to the scoring blade, select the scoring image and press cut again.
These steps can be done in reverse also, you can score first and cut second.
Hope this helped.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.