Groups: Registered
Joined: 8/17/2012(UTC)
Posts: 1
|
I am trying to create a very large image. Is there a way to take an image and only cut half of it that way I can piece them together? I am trying to cut a dirt bike from the Dude cartridge, but need the tires to be around 4.5" (the size of a CD), which makes this image too large for the mat and the image will not cut. I have been playing in the Craft Room and cannot figure it out. Any suggestions would be grateful!
|
|
|
|
|
|
Groups: Registered
Joined: 8/18/2012(UTC)
Posts: 42
Was thanked: 12 time(s) in 6 post(s)
|
It is my understanding that in CCR u can ONLY cut as big as ur mat.. A CD size circle would fit on my Mini mat. I would just highlight it and expand it to the size i needed. But not the entire bike. I would break down the bike to as many pieces as possible to make the biggest piece as large as my mat would allow and then the corresponding pieces a relative size. Cut individually. Does that help any?
|
|
|
|
|
|
Groups: Registered
Joined: 2/6/2011(UTC) Posts: 162  Thanks: 139 times
Was thanked: 52 time(s) in 33 post(s)
|
 I don't think that would be possible on CCR due to the fact that the Lite carts only have 4 'layers' - you can't try to break it any more than that. As far as I know, the only way to have a portion of a cut to cut (like the front half of the bike and then the back half later) is with the Gypsy [& Design Studio - I seem to remember having something too close to the edge and it stopped there & started again where the image was back in the cutting area of the mat].
I don't have Dude, but if you'd like, I can turn on my G and double check for you....
Gayle
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.