Groups: Registered
Joined: 10/6/2012(UTC)
Posts: 1
|
Hi,
I am getting an error message that says, Project didn't save properly...and then it won't cut! Help please!
Thanks,
A
|
|
|
|
|
|
Groups: Registered
Joined: 12/21/2011(UTC)
Posts: 57
Was thanked: 16 time(s) in 13 post(s)
|
That has happened to me too... usually when I leave CCR on for a little while without using it -- just exit out of the program, go back in, choose your project again and it should be fine...
|
|
|
|
|
|
Medals:  Groups: Registered, Circle Member
Joined: 2/21/2009(UTC)
Posts: 10,840
Location: Illinois
Thanks: 8630 times
Was thanked: 4373 time(s) in 2912 post(s)
|
Originally Posted by: texannette59a19bbcd2  Hi,
I am getting an error message that says, Project didn't save properly...and then it won't cut! Help please!
Thanks,
A I've gotten messages like that before (only a few times). I normally just wait a little bit and try again. Then, it seems to work fine. I hope you didn't lose a lot of work if it actually didn't save properly. I just had another thought....make sure you actually own the cartridges you have used on your project. Are you at least able to hit CUT and bring up the screen that shows all the cartridges you used in your project? Char Edited by user Monday, October 08, 2012 7:43:28 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.