Groups: Registered
Joined: 9/15/2006(UTC)
Posts: 580
Location: MQ Pg.11 #313
Thanks: 1 times
Was thanked: 59 time(s) in 56 post(s)
|
When using my Imagine tonight with CCR, the only machine I'm given to cut is the E2. The mat I was working on and machine chosen is the Imagine. Why does it only show the E2 as the choice to cut with ?
Kristin
|
|
|
|
|
|
Medals:  Groups: Registered, Circle Member, Circle Moderator, Cricut Community Moderator
Joined: 3/28/2011(UTC)
Posts: 442
Thanks: 1 times
Was thanked: 329 time(s) in 118 post(s)
|
K.McIntyre, Do you by any chance have both the Imagine and the E2 plugged into the computer? If so please disconnect the E2 and then see if the Cricut Craft Room program will recognize the Imagine. You can only have one machine plugged into the computer at a time when using any of our programs.I hope that this helps.
-PCGena
|
|
|
|
|
|
Groups: Registered
Joined: 9/15/2006(UTC)
Posts: 580
Location: MQ Pg.11 #313
Thanks: 1 times
Was thanked: 59 time(s) in 56 post(s)
|
No I do not. I removed the Wireless adapter from the E2 and turned it off. I then hooked up my PC to my Imagine, but the E2 showed as the only machine to select and cut. The computer never showed connecting to my Imagine.
Kristin
|
|
|
|
|
|
Medals: Groups: Registered, Circle Member, Circle Moderator, Cricut Community Moderator
Joined: 3/28/2011(UTC)
Posts: 442
Thanks: 1 times
Was thanked: 329 time(s) in 118 post(s)
|
I can suggest that you try installing the drivers for your Imagine. This may help your computer recognize your Imagine. Can you use the Cricut Sync program with your Imagine? Has it been updated lately?
-PCGena
|
|
|
|
|
|
Medals: Groups: Registered, Circle Member
Joined: 2/21/2009(UTC)
Posts: 10,847
Location: Illinois
Thanks: 8634 times
Was thanked: 4374 time(s) in 2913 post(s)
|
You do also need to make sure you have the machine designated on the left menus that you are wanting to use. Be sure it is designated before you go to the CUT feature and before you turn on your machine. You might have to REBOOT if you've tried to use a machine that's not designated, before you designate the correct machine and try to CUT. If you do a REBOOT, unplug the USB cord from the hard drive for ten or fifteen seconds before you REBOOT. You can plug it back in anytime before the machine reboots and/or after it reboots; then, go back into CCR.
Go to the menu MACHINE and select the machine you're using. If you use more than one machine, you will have to change it back each time you use the "other" machine.
HTH.
Char
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.