Groups: Registered
Joined: 7/14/2012(UTC) Posts: 1 
|
I don't know if I am on the right board for this. If I am not, could you please point me in the right direction? I am trying to cut craft foam with my E2 and I cannot get it to cut thru since doing it the first time. I went thru with a customer service person and reset the settings and saved them. I got it to cut but the font I was using wasn't good for the foam. So I got another font, which works fairly well with foam but now the E2 will not cut thru the foam. The blade also leaves marks on the foam as well. Does anyone have any experience with cutting craft foam? Thanks.
Holly
|
|
|
|
|
|
Groups: Registered
Joined: 12/3/2007(UTC)
Posts: 365
Location: Des Moines, Iowa.. MQ pg 10 Post 300
Thanks: 77 times
Was thanked: 56 time(s) in 49 post(s)
|
Well, I would imagine you need a deep cut housing blade, and a multi cut.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.